PEEK Rod | Black 30% Carbon Filled
 MouseOver to Zoom.


PEEK Rod | Black 30% Carbon Filled

30% carbon filled PEEK rod

Get Your Online Pricing: Tips for measuring »

How To Measure and Cut-To-Size Policy [X]

Cut-To-Size Items are Non-Returnable!

As per our Shipping and Returns Policy, custom cuts and fabricated parts are non-returnable. If you need an over- or undersized item, note it under "Comments" during Checkout. Cut-to-size orders have an acceptable cut tolerance of 1/8" (0.125"), so clarify if the adjustment is to be made on the (+) or (-) side of the saw blade. Please review our full return and shipping policy here.

Measure Twice, Cut Once

Since custom cuts and fabricated parts are non-refundable, be very careful while measuring your dimensions. As each cut is nominal, even the slightest miscalculation could be costly.

How to Use a Measuring Tape

Extend your tape measure several inches to find the 1 and 2 inch markers. In between the inch markers you’ll find 16 equally spaced tick marks.

Measure by counting the increments beyond the nearest inch. As the increments decrease, so does the length of the mark. For example, 1/2" has a bigger mark than 1/4" which has a bigger mark than 1/8". The smallest mark follows at 1/16". Please be aware that some measuring tapes may have even smaller increments.

Features of a Measuring Tape: Sliding End Hook

The sliding end hook is designed for two different types of measurements. An outside measurement (where the hook of the tape hangs over an edge), requires the hook to slide out a bit to account for the thickness of the material. When making an inside measurement (where the hook will push up against a surface), the clip slides in, again, accounting for its thickness. The measuring tape self-adjusts to guarantee an accurate measurement (as far as the tape is concerned).

Please Call us at (916) 679-5146 for pricing.
 50mm dia. x 39.38" Rod
 2" dia. x 12" Rod
 2" dia. x 72" Rod
 2" dia. x 96" Rod
 2.25" dia. x 12" Rod
As low as $9/month with

Overview Specs & Uses Reviews Inquiry
PEKBEA3RR - Overview

Black carbon filled 30% PEEK features carbon fiber reinforcement that increases PEEK's rigidity and creep strength. It has high mechanical strength properties with a lower density than 30% glass filled PEEK. Compared to glass, carbon fibers are typically less abrasive but improve the material's friction and wear characteristics. Great chemical resistance, radiation resistance, and inherent flame resistance in combination with its other excellent properties makes carbon filled PEEK a desirable material in many critical applications across several industries.

  • Great chemical resistance
  • High stiffness, creep resistance
  • High dimensional stability
  • Inherent flame resistance
  • Good heat deflection temperature
  • Resists high energy radiation

Material Warnings

Material Warning  WARNING: This product can expose you to chemicals including Carbon Black, CAS 1333-86-4, which are known to the State of California to cause cancer. For more information go to?

WARNING: SHARP EDGES. Handle with care.
Warning: This product may have sharp edges and points. Contact may result in injury. Handle with care.

Disclaimer: Interstate Plastics makes no representations about any of its products that are modified in any way after they leave its possession, nor do its representations apply when any of its products are improperly used or stored. Each customer of Interstate Plastics bears full responsibility for making its own determination as to the suitability of each material, product, recommendation or advice provided by Interstate Plastics. Each customer of Interstate Plastics must identify and perform all tests and analyses necessary to assure that its finished parts incorporating materials from Interstate Plastics will be safe and suitable for use under end-use conditions.

Interstate Plastics Suppliers